- View online Installation and setup manual for Honeywell ADEMCO 6150 Keypad or simply click Download button to examine the Honeywell ADEMCO 6150 guidelines offline on your desktop or laptop computer.
- The ADEMCO 6150 and ADEMCO 6160 are addressable Remote Keypads designed for use with ADEMCO control panels. Addresses are set via the keypad keys. The keys on the keypads are continuously backlit for convenience. Supervised by control panel (if supported).
- Honeywell 6160 Keypad Programming Manual Pdf
- Honeywell Security Keypad 6160 Manual
- Honeywell 6160 Keypad User Manual
- Ademco 6160 User Manual
- Honeywell Alarm Keypad 6160 Manual
- 6160 Honeywell Keypad Manual Download
- 6160 Honeywell Keypad Manual Diagram
Download Installation and setup manual of Honeywell ADEMCO 6150 Keypad for Free or View it Online on All-Guides.com.
Brand: Honeywell
Install a Honeywell 6160 keypad to the control panel's keypad terminals as shown in the installation manual. Once installed, to enable the 6160 keypad, start by setting the address at the keypad. The main keypad address should be addressed to 16. The keypad's default address is 31. Each keypad must be assigned a unique address. Keypads programmed with the same address will provide unpredictable.
Category: Keypad
Type: Installation and setup manual
Model: Honeywell ADEMCO 6150 , Honeywell ADEMCO 6160
Pages: 2
ADEMCO 6150 & 6160
INSTALLATION AND SETUP GUIDE
ADEMCO 6150
ADEMCO 6160
Backlit Display YES (see note) YES (see note)
Built-in Sounder Piezo Speaker
Note: Permanent display backlighting is an option on some controls (see the control's instructions for details).
The ADEMCO 6150 and ADEMCO 6160 are addressable
Remote Keypads designed for use with ADEMCO control
The keys on the keypads are continuously backlit for
KEYPAD DISPLAYS AND LEDS
Model
Word
2-line
Display
Identifier
Zone
6150 X X
The following table shows the LEDs and their functions:
Red Lights when the system is armed in any mode
Green Lights when the system is 'ready' to be armed.
The keypads also feature function keys. These keys may be
programmed for panic alarms or other special functions such
as macros. See the control's instructions for details.
The keypads can be surface mounted directly to a drywall, or to
1.Remove the case back by pushing down two 'snaps.'
2.Route wiring from the control panel through the
3.Mount the case back to a wall or electrical box.
4.Wire directly from the keypad’s terminal block to the
Wiring Table (All Keypads)
GData InGreen
++ Aux. PwrRed
See the control panel’s Installation and Setup Guide for
Honeywell 6160 Keypad Programming Manual Pdf
5.Reattach the keypad to its case back.
Honeywell Security Keypad 6160 Manual
SNAPS
TO REMOVE CASE BACK
SNAPS LOCATED ALONG THE
AND LIFT UP.
ARMED
![Keypad Keypad](https://www.alarmrelay.com/wp-content/uploads/2017/04/6160-Keypad-3.jpg)
Function keys must be held down for at
Honeywell 6160 Keypad User Manual
pairs activate immediately.
Ademco 6160 User Manual
A or [1] and [✱]
C or [3] and [#]